[shaq18]

so ive been out of commission for a while... but im back.... i have to say... i have been on a few fta sites..... and this site is by far the best and most helpful of them all...

woodcreeker..... thank you so very much for all of your continuous help.

i still continue to have the same problems as i have had previously.

my satellite is set properly with an azimuth of 236, elevation of 41 and skew of 135...

on my sub receiver, i am able to get strength of above 80 for both 118 and 119 with a transponder of 20. but the 110 is zero. when i change the transponder to 22 on the sub receiver the 110 jumps up to above 80.


again the sub is dishnetwork receiver model 1000.

on my sonicview, i am able to catch 119 but still cant get 110. ive tried changing the transponder but still only get 119. When i go into dish settings, below the graph it does say echostar 8. but above the graph it says echostar 7 (119). i am never able to get it to say 110 echostar 8 above the graph at all the transponder settings ive tried.

the wiring and everything is fine, ive double checked everything including the wires coming from the lnb's to the switch. and everything is set correctly.

everything is set up exactly how you have it in the picture you have provided.

ive also tried to change stuff with the sub receiver on, or off it doesnt make a difference.

the dish is posted with a pole which is in the ground. im not sure which way it is pointing i have no compass.

thank you all again for any help you can provide me. and thank you again woodcreeker.