[woodcreeker]

Captiveworks CW-800S CW-700S How To Fix Loading v1.95 Bin File Problem

Keep in mind here that loading the v1.93 bin file was a necessary upgrade.

Installing from file versions 1.89 or before:
1. Save Channel List if you want to keep it
2. Do Factory Default
3. Load Bin file Version 1.93 (Follow Release Notes)
4. Enter 9 or 10 Digit Serial Number Located on bottom of receiver
5. Do Factory Default again
6. Load current bin version 1.95
7. Load Saved Channel List or Setup Satellites and Rescan
8. Exit out of menu and make sure Patch Enabled

[To enable patch -> Hit F1 on remote, enter 000 (3 zeros)]

Installing from 1.93 or greater:
1. Save Channel List if you did not do Factory Default when you loaded 1.93 before
2. Load current file 1.95 and do Factory Default if you get error messages
3. If you had to do Factory Default now Load your Saved Channel List
4. Exit out of menu and make sure Patch Enabled F1 000

Installing from a box already screwed up:
1. Turn box off from rear
2. Press and hold down the power button on the front of the box while turning back ON from the rear and wait till you see the word "BOOT" on the front display for a few seconds then you can let go of the front power button.
3. Connect receiver using a 9 pin Null Modem serial cable (NOT a USB drive)
4. Using serial loader v1.03, load bin file Version 1.93 and follow all of the Release Notes with that file.
4. Enter the 9 or 10 Digit Serial Number Located on bottom of receiver.
5. Do Factory Default again.
6. Load current bin version 1.95
7. Load Saved Channel List or Setup Sats and Rescan
8. Exit out of menu and make sure Patch Enabled (F1 000)

[If at anytime it asks for a password use master password 9876 if 0000 does not work]

Installing from Factory New Box:
1. Turn Box on and go to menu and do Factory Default and reboot box (This step is a must)
2. Load Current Release file, on reboot you will see ERROR 020 on display this is ok now Enter 9 or 10 Digit Serial Number Located on bottom of receiver after reboot do another Factory Default and reboot box again now you will not see ERROR 020 anymore on boot up.
3. Load a saved channel list (reboot box after loading list) or setup box from scratch and rescan all
4. Exit out of all menus and ENABLE PATCH (F1 000)
5. Wait for Keys to roll then watch TV (could take up to 7 minutes to roll)

[HENRY MADRID]

hi can anybody tell me how to load the 1.03 loader intothe serial where my computer cannot detect the serial cable. what todo?

[woodcreeker]

Try this -> New Captiveworks CW-800S PVR CW800S Serial Loader V1.04

It is a new loader designed to work with a USB To Serial Adapter cable.

Also, read this -> USB To Serial Adapters - Help Guide For Loader Problems