![]() |
![]() |
![]() |
![]() |
| Dish Pointing Help Find out how to sight in those satellites with your dish here. |
![]() |
|
|
LinkBack (1) | Thread Tools |
|
|
#1 (permalink)
|
||||||||||||||||||||
|
New Member
Join Date: Nov 2007
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 3
![]()
|
need help with dish pointing at 91
i have dish 500 with y bracket and a single lnb at the right viewing from the back of the dish. i am trying to hit 91 but no luck at all. dishpointer gives me elevation at 42.4, skew at 16.7 degrees and azimuth at 212.7 for my zip at 20707. i wasn't sure if i were to add 90 to the skew or subtract from 90, anyway tried both but no luck at all. i am getting signal in the 80's but the quality never goes up above 7.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#2 (permalink) | ||||||||||||||||||||
|
Super Moderator
Join Date: Mar 2008
Posts: 5,131
Thanks: 1,729
Thanked 3,640 Times in 1,831 Posts
Rep Power: 10
![]() ![]()
|
Re: need help with dish pointing at 91
How do you have the antenna setup in the menu system on you stb. Q is signal strength.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#3 (permalink) | ||||||||||||||||||||
|
New Member
Join Date: Nov 2007
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 3
![]()
|
Re: need help with dish pointing at 91
in the setting lnb power is on, lnb type is single, not using switch so it is off. s is in the 80's as mention above and q is around 7.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#4 (permalink) | ||||||||||||||||||||
|
Super Moderator
Join Date: Mar 2008
Posts: 5,131
Thanks: 1,729
Thanked 3,640 Times in 1,831 Posts
Rep Power: 10
![]() ![]()
|
Re: need help with dish pointing at 91
What is the lnb freq and what trans are you using to check signal.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#5 (permalink) | ||||||||||||||||||||
|
AAAFTA Site Helper
Join Date: Apr 2008
Posts: 652
Thanks: 154
Thanked 457 Times in 243 Posts
Rep Power: 2
![]()
|
Re: need help with dish pointing at 91
you normally would not need to skew a single lnb dish. skewing allows you to put 1 lnb higher or lower than the other in multi-lnb setups.
work with bobo, he will fix you up, likely its a setting or pointing problem. |
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#6 (permalink) | ||||||||||||||||||||
|
GMA-PinoyTV
Join Date: Dec 2007
Location: Mabuhay tayong lahat
Posts: 1,842
Thanks: 538
Thanked 1,792 Times in 676 Posts
Rep Power: 5
![]()
|
Re: need help with dish pointing at 91
91W the setting is LNB freq. 11250--> LNB type ocs-dp--> tp freq. 12224.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#7 (permalink) | ||||||||||||||||||||
|
New Member
Join Date: Nov 2007
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 3
![]()
|
Re: need help with dish pointing at 91
hi guys the lnb freq = 11250, i changed the lnb type to osc dp from single but no change and as far as the tp freq i don't see the option for that
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#8 (permalink) | ||||||||||||||||||||
|
GMA-PinoyTV
Join Date: Dec 2007
Location: Mabuhay tayong lahat
Posts: 1,842
Thanks: 538
Thanked 1,792 Times in 676 Posts
Rep Power: 5
![]()
|
Re: need help with dish pointing at 91
You can see the Tp freq below the LNB freq.
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#9 (permalink) | ||||||||||||||||||||
|
New Member
Join Date: Nov 2007
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 3
![]()
|
Re: need help with dish pointing at 91
thanks for your help guys, was using cs 6k just to check for the signal and it doesn't have tp freq option, will try with nfusion i know i can change to different tp freq. will have to do in the morning and post the result. once again i appreciate your help so far
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
| The Following User Says Thank You to usualsuspects For This Useful Post: | cdo_care (08-06-2008) |
|
|
#10 (permalink) | ||||||||||||||||||||
|
Super Moderator
Join Date: Aug 2007
Location: AAAFTA Forum
Posts: 9,844
Thanks: 1,295
Thanked 8,503 Times in 3,425 Posts
Rep Power: 10
![]() ![]()
|
Re: need help with dish pointing at 91
The LNB for Nimiq 1 should be in the left LNB position. Then, if you ever get an LNB for the other side, you might probably have Nimiq 2 sighted in as well. The skew factor you got is probably erronous, and throwing you off. There are two types of skew. Dish skew (skewing the dish) and LNB skew (swiveling the LNB in the case of an LNB mounted in an LNB holder by the neck). This might have thrown you.
Like hazwis said, the skew is not necessary, Nimiq 1 is high in the sky, and probably more towards the south than you think it is. I think maybe your numbers didn't help as you have the LNB on the side, and not in the middle. I bet the numbers you have are for an 18" single LNB dish. I would try to level the dish, maybe set the skew on the back around 85, have the LNB in the East LNB holder on the Y yoke, aim it around due south, and have your elevation set high, around 45. Move the towards the West slightly, and you should find Nimiq 1 right in there, if you don't see it already. Oh yeah, just run a line directly to the LNB from the receiver, and have the settings.. LNB Type: Standard LNB Freq: 11250 No DiSEqC No 22KHz No nothing, LOL Hope This Helps !!
__________________
If this site has helped in any way, please help out and click on the Donate graphic below The reason we are asking is because we are a small site and all expenses are out of pocket. In order to maintain and keep the site running it costs lots of money for server costs, maintenance, etc. It's more than one can be obligated to pay and we hope you can find it in your hearts to help support this site so we can continue to give you great support. |
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
|
#11 (permalink) | ||||||||||||||||||||
|
New Member
Join Date: Nov 2007
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 3
![]()
|
Re: need help with dish pointing at 91
hi guys i want to thank you all for your help. i placed the lnb to the left on the y bracket and played with the azimuth, and after a while a got 91. my question now is that my nf won't lock on to the sat. used cs 6k scanned the sat and got channels eventhough scrambled which is not a surprise. i was wondering if some1 can help me with that
|
||||||||||||||||||||
|
|
|
||||||||||||||||||||
![]() |
LinkBacks (?)
LinkBack to this Thread: http://www.aaafta.com/forum/dish-pointing-help/7930-need-help-dish-pointing-91-a.html
|
|||
| Posted By | For | Type | Date |
| AAAFTA Receiver Setup Bin Files Help | This thread | Refback | 08-07-2008 01:32 PM |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help with dish pointing | Pagaal | Dish Pointing Help | 14 | 06-09-2009 02:23 PM |
| dish pointing | addict | General Chit Chat | 0 | 06-08-2009 12:14 AM |
| Dish pointing | browjaso | Dish Pointing Help | 1 | 02-03-2009 01:53 PM |
| Pointing Dish? | raj0654 | General Receiver Discussions and Help | 1 | 11-23-2008 01:38 AM |