[woodcreeker]

Bin Change Your Fortec Ultra into a Pansat 2700

NO Jtag required

I would do a factory reset 3 times first before doing this. If you are using Channel Master, you can write your channels to your computer before doing the factory resets.

1. Open/Run the Blacklist updater included
2. Make sure BIN is Selected not BOOT you are writing a BIN
3. Click select BIN
4. Choose j27_205_1.bin
5. Reboot reciever, on first light/dash, Click write bin. Let it write
When it is done, Be PATIENT!!!! Let it reboot after 2-3 minutes you will see B-75 Flash on display of reciever.
6. Click select BIN
7. Choose jvvh_208_1.bin
8. Reboot reciever on first light Click write bin. let it write. Let it reboot after 1 minute you will see B-75 Flash on display of receiver, then it will go to On.
9. Turn OFF, then ON and write the latest Jvvh bin file.
10. Now Rewrite your Channel list back, BUT, BIG BUT, you must now select the Pansat 2700 settings in Channel Master to write. Or if you don't use Channel Master, setup satellites, exit, and blind scan each satellites channels back in.
11. Reconnect to TV, select default key from parental options (key menu) Let the keys roll in.

Good Luck !!