[ifakhour]

hello please need ur help i got a cw4000hd and two dishes trubohd 1000.2 and a dish 500 i hooked up the dish 500 to in input on the 1000.2 then ran into cw 4000 i only can get a signal 110 not 119 and 129 61.5 what do i do

[ifakhour]

what in need please is what info do i put for
switch=disqc, mini diseqc, none, uncommitted, 22 khz tone
under LNB = dp lin, wb circ, cband, switch, motor, none, univ, univ2, circular, linear, dp circ
thats the help i need i think the 1000.2 has a built in switch and an input for 61.5 thank

[woodcreeker]

You need to change the TP numbers to see signal from all satellites. See, whenever you into the settings, the default TP 12224 probably appears. That needs to be changed to see the signal everytime you go into the setup.

Here are the settings you may require:

Echo 7 119W
LNB Power: On
LNB Type: OCS-DP
LNB Freq: 11250
22KHz: Off
TP: 12239
DiSEqC: Port 1
Motor: Off
Legacy SW: None

Echo 8 110W
LNB Power: On
LNB Type: OCS-DP
LNB Freq: 11250
22KHz: Off
TP: 12224
DiSEqC: Port 2
Motor: Off
Legacy SW: None


Echo 5 129W
LNB Power: On
LNB Type: OCS-DP
LNB Freq: 11250
22KHz: Off
TP: 12282
DiSEqC: Port 3
Motor: Off
Legacy SW: None

Echo 3 61.5W
LNB Power: On
LNB Type: OCS-DP
LNB Freq: 11250
22KHz: Off
TP: 12297
DiSEqC: Port 4
Motor: Off
Legacy SW: None

[ifakhour]

i dont have ocs-dp for the lpn i have these to choose from
dp lin, wb circ, cband, switch, motor, none, univ, univ2, circular, linear, dp circ

[woodcreeker]

Check your PMs, sorry for not getting back to this. From the choices listed, the LNB type has to be DP Circular. Since this receiver is so new, I haven't seen the actual menus for this receiver model yet.

Check your Private Messages, too.