[kamelkadri]

i have turned fortec ultra to a pansat 2700A as it's been descriped on your website and followed every step, i install the factory flash:Pansat 2700A_050217_100_api(N)_1 , and after that i nstall the newest bin file on this website wich's : x-87bl_071208_b75_228_api , now i try to scan the channells and on any satelite i get the same channells,and it wont work ,the light on the front of receiver is on with numbers but no signal and it says(scrambled or bad channell) i try to turn it off from the back and on again it won't help and it stays the same, dowloading the files to this machine is fine with : black list stb updater 1.4.0.0, but it won't work with pansat updater or loader, now is there anyone can help with this problem ? same chanells on any satelite, and the transponders i get is the (H) ones and no (V) ones at all ,,,, if this is not understandable please ask me something ............

[woodcreeker]

You were only suppose to load these special conversion bins that are posted in your receiver section. You CANNOT use a regular Pansat 2700A bin after this conversion. The receiver that is converted need the regular Pansat 2700A bins compressed down in size and made to work only on these converted receivers. There is not enough memory in your Fortec Ultra to run one of these regular Pansat 2700A bins.

After this conversion, only use the CS Lightning bins, or the JVVH bins.

You may need to JTAG your receiver now. Try to start by writing the factory bin you have in the package, factory reset it a couple of times, and try one of the CS Lightning bins.