[woodcreeker]

Pansat 2500 Into Pansat 2700 Bin Conversion - No JTAG - Easy

Bin Change Your Pansat 2500 into a Pansat 2700

NO Jtag required

I would do a factory reset 3 times first before doing this. If you are using Channel Master, you can write your channels to your computer before doing the factory resets.

1. Open/Run the Blacklist updater included
2. Make sure BIN is Selected not BOOT you are writing a BIN
3. Click select BIN
4. Choose j27_205_1.bin
5. Reboot reciever, on first light/dash, Click write bin. Let it write
When it is done, Be VERY PATIENT!!!! Let it reboot after 2-3 minutes you will see B-75 Flash on display of reciever.
6. Click select BIN
7. Choose jvvh_208_1.bin
8. Reboot reciever on first light Click write bin. let it write. Let it reboot after 1 minute you will see B-75 Flash on display of receiver, then it will go to On.
9. Turn OFF, then ON from the rear switch, and write the new latest jvvh bin file release.
* Note - the latest new jvvh 2700 bin ONLY, no Pansat 2700 bins, and NOT clone 2700 Tivo bins. You will not need to do this upgrade again, just this ONE time, then simply write the latest jvvh bin from now on.
10. Now Rewrite your Channel list back, BUT, BIG BUT, you must now select the Pansat 2700 settings in Channel Master to write. Or if you don't use Channel Master, setup satellites, exit, and blind scan each satellites channels back in.
11. Reconnect to TV, select default key from parental options (key menu) Let the keys roll in.