[woodcreeker]

Pansat 9200HD Technical Bulletin (June 18, 2008)

Subject: e-Sata External PVR Operation Ready Fix
Model: Pansat 9200HD Early Production (sold before Jan, 2008)July, 2007 (S/N : 7H~ series)
Oct, 2007 (S/N : 7J~ series)
**** Nov, 2007 (S/N : 7K~ series) production OK (sold after Feb, 2008)
Modification: Relocate TR Q3 (MMBT 2222A Fairchild) as per attached photo.
Verification: After relocating the Q3 TR base (or C178) the voltage should be 1.8V DC from 0V

Recommendation

If these instructions are too difficult for you to follow or you can not find a qualified installer to make the modification, please send the whole unit back to the Panarex Service Department because you will be charged to have the PCB board replaced if you make a severe damage mistake. The fee will be based on the actual price of the board. (Around $200.00)

1. Find and hire an excellent qualified technician nearest to your location.
2. Desolder & remove the part TR(Q3) quickly. (Not more than 2~3 seconds to avoid PCB pattern damage)
3. Clean the main PCB board Q3 TR area and removed TR legs and solder again with new direction
as per the attached photo. (Should you need new TR, contact the Panarex Service Dept to request it)
4. You need to check the C178 leg (or TR bare) measures 1.8V DC.

Panarex Electronics
11672 Tuxford St., Sun Valley, CA 91352 USA
Tel : 818-768-5161 Fax : 818-768-5191
E-mail : pansatusa@cs.com





BEFORE:





AFTER: