[redcindie]

Hey woodcreeker thanks so very much, i do appreciate it. When you get a chance let me know what else to do. This is a great place for all the help I need. thanks again

[woodcreeker]

Originally Posted by redcindie

thank you so much. ok this is what i see. there are 2 on the on west side and 1 on east side. the come together in some sort of junction box and come into the house as 1. i do not see any switches

The juction box as you call it should be a DP34 switch. Since the Lone LNB is on the East side, that LNB is for 119W, and that LNB should be connected on the side to the port marked 1 on the DP34 switch. Now of the other 2 LNBs next to each other, the farthest West LNB is for 105W, and the LNB in the middle of the 3 LNBs is for 110W. This LNB should be connected to Port 2 on the side of the DP34. You do not need the West LNB connected. In fact, it may be wise to disconnect it. Check this wiring, as it is paramount for it to be correct and match the settings I am giving you below.

Echo 7/Ku (119W)
LNB Power: On
LNB Type: Dish-Pro
LNB Freq: 11250
22KHz: Off
DiSEqC: (1.0) #1
Legacy SW: None
TP: [2] 12239 H 20.000
Postioner setting: Disable
Satellite Scan: ALL

Echo 8.10/Ku (110W)
LNB Power: On
LNB Type: Dish-Pro
LNB Freq: 11250
22KHz: Off
DiSEqC: (1.0) #2
Legacy SW: None
TP: [1] 12224 V 20.000
Postioner setting: Disable
Satellite Scan: ALL

Now it is best for you to do the Menu -> Factory Setting -> 0000 (four zeros) -> Ok
This is called a Factory Reset. All this does is deletes channels and settings.

Then put in each of the settings above for each satellite and Exit and Save each.
Then go down to Blind Scan and blind scan each satellite 110W and 119W only once.
Save each scan of course when they are done.
You will also need to change your Time Zone to your area, Summer Time ON.
You may also want to enter your State / City under Renumbering Local CH.

Should fix you all up.