Fix for version 82 and Wiznet

[buddyjh]

c/p from tb1971

If you have a version 82 reading in the top left hand corner of your Wiznet Loader , you shouldnt. It should read either 1.0 or 1.4 if you have updated your IHUB. The reason you probably got version 82 in your wiznet is because you factory defaluted/restore your receiver.
To resolve this problem follow these steps:

1. Download IHUB rom100 to your desktop and unzip the file.

2. Open wiznet and click search, then upload the 0100 file


3. Once upload is complete, close wiznet, then re-open wiznet and click on the search tab.

4. Version information in the top left hand corner now will show 1.0.

5. Reload: system clean file- which wipes all version of previously loaded software except the Factory file that your receiver came with.

6. Once you have done this turn receiver off at the switch, then turn back on.

7. After you have followed these steps you will then update your IHUB to version 1.4. This is done the exact same way as listed above.

8. Load latest version for IHUB(for me it was 209) with USB thumb drive, (just like you have done with all previous files)

***If you factory default your receiver all you are doing is erasing all your settings and not any files***

***If you want to erase all files and start all over, you need to run system clean file***
I hope this helps, feel free to make some suggestion or add to my testing results!